Power supply: 2 LR6 (1.5V) Alkaline batteries
Maximum load: 5 A (resistive), 0.95 A (inductive) @ 240 VAC
Power across UN terminals: 20 mA @ 12 VDC
Setpoint range: 5 to 28°C
The display illuminates for 12 seconds when the backlight button or
any other button is pressed.
.2 Displaying the Temperature
Display range: -10 to 50°C
The actual (measured) temperature is normally displayed. To view
the setpoint temperature, press once on either of the buttons.
icon, will be displayed for the next 5
Display resolution: 0.5°C
Accuracy: ± 0.5°C
The setpoint, along with the
Cycle length: 10, 12, 15, 20 or 30 minutes (programmable)
.3 Setting the Temperature
Storage temperature: -20 to 50°C
Dimensions: 127 mm x 75 mm x 28 mm
Press one of the
buttons until the desired temperature is dis-
.4 Unoccupied Mode (TH148ELE only)
To place the thermostat in unoccupied mode, see section 2.4. When
the thermostat is in this mode, the unoccupied mode setpoint is used
Aube warrants this product, excluding battery, to be free from defects in the
workmanship or materials, under normal use and service, for a period of three
(3) years from the date of purchase by the consumer. If at any time during the
warranty period the product is determined to be defective or malfunctions,
Aube shall repair or replace it (at Aube's option).
(see section 4) and the
icon is displayed.
If you modify the setpoint temperature when the thermostat is in
unoccupied mode, the new setpoint will be used for the next 2
hours. Afterwards, the thermostat will return to the unoccupied
If the product is defective,
i) return it, with a bill of sale or other dated proof of purchase, to the place
from which you purchased it, or
mode setpoint. The
icon flashes during the bypass.
(ii) call Aube Technical Support at 33 (0) 1 34 07 99 00. Technical Support
will make the determination whether the product should be returned to
the following address: 10 rue Ampère, 95500 Gonesse, France, or
whether a replacement product can be sent to you.
.5 Low-battery Indicator
An icon appears when the batteries need replacement.
This icon will flash for 60 days, afterwards the thermo-
stat will cut power to the heating system. The icon dis-
appears once the batteries are replaced.
This warranty does not cover removal or reinstallation costs. This warranty
shall not apply if it is shown by Aube that the defect or malfunction was
caused by damage which occurred while the product was in the possession of
Aube's sole responsibility shall be to repair or replace the product within the
terms stated above. AUBE SHALL NOT BE LIABLE FOR ANY LOSS OR
DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY
BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER
FAILURE OF THIS PRODUCT. Some regions do not allow the exclusion or
limitation of incidental or consequential damages, so this limitation may not
apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY AUBE MAKES ON
THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES,
INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-
YEAR DURATION OF THIS WARRANTY. Some regions do not allow limita-
tions on how long an implied warranty lasts, so the above limitation may not
apply to you.
Note: The setpoint temperature is unaffected when the batteries are
removed from the thermostat.
n Press the backlight button until the configuration menu appears
o To go to the next parameter (menu item), press the backlight but-
ton (1 second).
p To modify a parameter, press
q Repeat steps 2 and 3 if necessary.
This warranty gives you specific legal rights, and you may have other rights
which vary from region to region.
If you have any questions concerning this warranty, please write Aube, 705
Montrichard, Saint-Jean-sur-Richelieu, Quebec J2X 5K8 Canada.
r To end, press the backlight button until the configuration menu
disappears (3 seconds).
Pump protection 1
Unoccupied mode temperature 2
On or Off
For any questions regarding the product installation or operation,
contact our technical support team at
5°C to 28°C
Number of cycles per hour 3
Tel.: 33 (0) 1 34 07 99 00
Fax: 33 (0) 1 34 07 99 19
2, 3, 4, 5 or 6
When pump protection is On, the thermostat will activate the heating sys-
tem for 15 seconds if it has not been activated for the past 24 hours.
See section 3.4.
For more information on our products, visit us at
The corresponding cycle lengths are: 2=30 min., 3=20 min., 4=15 min.,
=12 min., 6=10 min. The corresponding cycle lengths are: 2=30 min.,
=20 min., 4=15 min., 5=12 min., 6=10 min. Select the cycle according to
the type of heating: gas boiler <30kW: 10 minutes; oil boiler: 20 minutes
TH147E & TH148ELE